Display Thresholds (Dst) - Paradyne COMSPHERE 6800 Series Command Reference Manual

COMSPHERE 6800 Series Network Management System

Display Thresholds (dst)

Use the dst command to display the current fault threshold set on COMSPHERE 3400/4400 Series
devices which determine when alerts should be generated. Threshold (TH) alerts are generated
when the line parameters exceed the thresholds defined by the Change Thresholds (cht) command.
For most commands, NMS enables you to specify the destination for the command's results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level:
Abbreviation:
Restrictions:
Routine:
Schedule:
Related Commands: Change Thresholds (cht)
Display Thresholds Input Form
This input form contains the following field:
Device(s) (Required field)
Display Thresholds Results Form
The Display Thresholds results form lists device information for each device specified, and
displays the threshold information applicable to the device.
This results form contains the following fields:
Receive level (high)
Receive level (low)
Signal-to-noise ratio
2-142
Help Desk, Data Technician, Manager, System Administrator
dst
None
Yes
Yes
Enter the device(s) for which thresholds are to be displayed. One or more devices may be
specified. Standard addressing format applies to the input. For information on device
addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management
System User's/System Administrator's Guide.
Displays the high received signal level that causes a device to report a threshold alert.
Displays the low received signal level that causes a device to report a threshold alert.
Displays a signal-to-noise ratio that, when exceeded, triggers a threshold alert.
January 1997 6800-A2-GB31-20