Configuration Change Notification (Ccn) - Paradyne COMSPHERE 6800 Series Command Reference Manual

Configuration Change Notification (ccn)

Use the ccn command to display the configuration events that have occurred on a COMSPHERE
device. You can also use this command to clear the memory area in the device where the
configuration events are stored.
For most commands, NMS enables you to specify the destination for the command's results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level:
Abbreviation:
Restrictions:
Routine:
Schedule:
Related Commands: Configuration Change Notification Enable/Disable (ccned)
Configuration Change Notification Input Form
The Configuration Change Notification input form contains the following fields:
Device(s) (Required field)
Test state (Required field)
6800-A2-GB31-20
Help Desk, Data Technician, Manager, System Administrator
ccn
None
Yes
Yes
Enter the device(s) whose configuration changes will be displayed. One or more devices
may be specified. Standard addressing format applies to the input. For information on
device addressing, refer to Appendix D of the COMSPHERE 6800 Series Network
Management System User's/System Administrator's Guide.
Enter display to display configuration events for the device(s) specified.
Enter clear to display the configuration events for the specified device(s), and then clear
memory.
A pop-up menu is available listing valid selections.
January 1997
2Modem/DSU Commands
2-89