Call Fault Criteria Input Form, Page 2 - Paradyne COMSPHERE 6800 Series Command Reference Manual

Page 2
Page 2 enables you to set the criteria for the non-answering data set fault, and the short holding
time fault. Figure 2-6 is a sample of Page 2 of the Call Fault Criteria input form.
The input form page 2 is changed as follows:
is changed to
This input form contains the following fields:
NON-ANSWERING DATA SET FAULT CRITERIA
Incoming calls/sample (Required field)
Maximum number of non-answered calls/sample (Required field)
6800-A2-GB31-20
Figure 2-6. Call Fault Criteria Input Form, Page 2
Action upon exceeding minimum average
Action upon not meeting minimum average
Enter the number of calls to be included in the sample. Valid entries are from 5 through
100.
Enter a number from 1 through 100 to define the maximum number of non-answered calls
in the sample. Must be less than or equal to the number specified in the Incoming
calls/sample field above.
January 1997
2Modem/DSU Commands
2-21