Disable/Enable (De) - Paradyne COMSPHERE 6800 Series Command Reference Manual

COMSPHERE 6800 Series Network Management System

Disable/Enable (de)

(Disruptive)
Use the de command to enable or disable the transmitter on COMSPHERE or DATAPHONE II
APL modems and COMSPHERE or DATAPHONE II DSUs.
For most commands, NMS enables you to specify the destination for the command's results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level:
Abbreviation:
Restrictions:
Routine:
Schedule:
Related Commands: None
Disable/Enable Input Form
This input form contains the following fields:
Device(s) (Required field)
Device state (Required field)
2-116
Data Technician, Manager, System Administrator
de
Alternate: dsab
When a device is disabled, primary data is affected; but the secondary
diagnostic channel operates and the device responds to polls from the
NMS. (This is not applicable to a COMSPHERE 3600 Series device.)
Yes
Yes
Enter the device(s) to be disabled/enabled. One or more devices may be specified.
Standard addressing format applies to the input. For information on device addressing,
refer to Appendix D of the COMSPHERE 6800 Series Network Management System
User's/System User's/System Administrator's Guide.
Enter the desired device state. Valid entries are disable and enable.
A pop-up menu is available listing valid selections.
January 1997 6800-A2-GB31-20