Service Line (Sl) - Paradyne COMSPHERE 6800 Series Command Reference Manual

COMSPHERE 6800 Series Network Management System

Service Line (sl)

Use the sl command to allow a ninth service telephone line to be assigned to one of the eight
DATAPHONE II or COMSPHERE 3800 Series Direct Distance Dial (DDD) control modems in a
carrier overseen by a single Shared Diagnostic Unit (SDU).
Placing the modem in the service line state makes the phone line associated with the modem busy,
and transfers the modem to the service line for testing purposes.
For most commands, NMS enables you to specify the destination for the command's results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level:
Abbreviation:
Restrictions:
Routine:
Schedule:
Related Commands: None
Service Line Input Form
This input form contains the following fields:
Device(s) (Required field)
Service line state (Required field)
Service Line Results Form
This results form lists device information for each device specified, displays the requested service
line state (service-line or release), and indicates whether or not the command was successfully
executed.
2-198
Data Technician, Manager, System Administrator
Abbreviation: sl
None
Yes
Yes
Enter the device(s) to which this command will be sent. One or more devices may be
specified. Standard addressing format applies to the input. For information on device
addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management
System User's/System Administrator's Guide.
Enter service-line to assign the service telephone line to the specified device(s). Enter
release to release the device(s) from the service line.
A pop-up menu is available listing valid selections.
January 1997 6800-A2-GB31-20