Display Options (Dso) - Paradyne COMSPHERE 6800 Series Command Reference Manual

Display Options (dso)

Use the dso command to display the current option settings on a COMSPHERE or DATAPHONE
II device.
For most commands, NMS enables you to specify the destination for the command's results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level:
Abbreviation:
Restrictions:
Routine:
Schedule:
Related Commands: Change Options (cho)
Display Options Input Form
This input form contains the following field:
Device(s) (Required field)
Display Options Results Forms
Options will vary according to the device type selected. The results forms list device information
for each specified device, and the set of options obtained from the device. See the Change Options
(cho) command description for the format of options displayed.
6800-A2-GB31-20
Help Desk, Data Technician, Manager, System Administrator
dso
Alternate: dsop
None
Yes
Yes
Enter the device(s) whose options are to be displayed. One or more devices may be
specified. Standard addressing format applies to the input. For information on device
addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management
System User's/System Administrator's Guide.
January 1997
2Modem/DSU Commands
2-133