Display Port Options (Dspo) - Paradyne COMSPHERE 6800 Series Command Reference Manual

COMSPHERE 6800 Series Network Management System

Display Port Options (dspo)

Use the dspo command to display the port options of one or more COMSPHERE 3400/4400 Series
APL modems with MSD/TDM.
For most commands, NMS enables you to specify the destination for the command's results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level:
Abbreviation:
Restrictions:
Routine:
Schedule:
Related Commands: Change Options (cho)
Display Port Options Input Form
This input form contains the following field:
Device(s) (Required field)
Display Port Options Results Form
Port options vary according to the device selected. The sample results forms shown in Figures 2-41
and 2-42 illustrate the first two pages of port options for a 3400/4400 Series 19.2 kbps modem.
2-136
Data Technician, Manager, System Administrator
dspo
Alternate: dsportop
None
Yes
Yes
Change Port Options (chpo)
Change Port Speed(s) (chpsp)
Display Port Speed(s) (dspsp)
Enter the device(s) whose port options are to be displayed. One or more devices may be
specified. Standard addressing format applies to the input. For information on device
addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management
System User's/System Administrator's Guide.
January 1997 6800-A2-GB31-20