Exception Reports (Er) - Paradyne COMSPHERE 6800 Series Command Reference Manual

Exception Reports (er)

(Disruptive Based on Test Type)
Use the er command to obtain exception reports for one or more of the tests listed below.
Exception reports are tabular listings of command results statistics for a specified command.
Exception reporting allows you to run tests and receive selective results based on the test reporting
thresholds established through the Change Exception Reporting Thresholds (chert) command.
For most commands, NMS enables you to specify the destination for the command's results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level:
Abbreviation:
6800-A2-GB31-20
Exception reports can be run for the following tests:
Automatic Network Test
Circuit Loss Inbound
Circuit Loss Outbound
Device Test
Digital Test
End-to-End Test
Offline Test
Receive Signal Level
Receive Signal Quality
Report Terminal Power
Signal Profile
You can change reporting thresholds for exception reporting only for
the following DATAPHONE II modems: 2024A, 2024T, 2048A,
2048C, 2048T, 2144A, 2248A, 2296A, 2192A.
Help Desk, Data Technician, Manager, System Administrator
er
January 1997
NOTE
2Modem/DSU Commands
2-159