Change Directory (Chd) - Paradyne COMSPHERE 6800 Series Command Reference Manual

Network management system, communications products support
Table of Contents

Advertisement

COMSPHERE 6800 Series Network Management System

Change Directory (chd)

Use the chd command to overwrite the telephone number and comments in a DATAPHONE DDD
modem's AUTOCALL dialer. If the directory update option in the modem is disabled, the NMS
receives an error message indicating the change cannot be made.
For most commands, NMS enables you to specify the destination for the command's results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level:
Abbreviation:
Restrictions:
Routine:
Schedule:
Related Commands: Change Telephone Number(s) (chtn)
Change Directory Input Form
The Change Directory input form contains the following fields:
Device (Required field)
Directory number (Required field)
Control characters replaced by ? (Display field)
2-46
Help Desk, Data Technician, Manager, System Administrator
chd
Alternate: chdir
None
Yes
Yes
Dial (dial)
Enter the device for which the telephone number is to be changed. Standard addressing
format applies to the input. For information on device addressing, refer to Appendix D of
the COMSPHERE 6800 Series Network Management System User's/System
Administrator's Guide.
Enter the number of the directory to be changed. Valid entries are from 1 through 99.
Indicates whether or not there are control characters in the comment portion of the
directory.
If the telephone number and comments in the directory were entered at the front panel of
the modem, the comment field may contain control characters. These control characters
cannot be displayed or entered on the NMS; a question mark (?) is displayed in place of
the control characters.
If there are control characters in the comment field, an error message warns you to cancel
the command to avoid deleting these characters.
January 1997
6800-A2-GB31-20

Advertisement

Table of Contents
loading

Table of Contents