Display Port Speed(S) (Dspsp) - Paradyne COMSPHERE 6800 Series Command Reference Manual

COMSPHERE 6800 Series Network Management System

Display Port Speed(s) (dspsp)

Use the dspsp command to display the port speed configuration of the ports on one or more
COMSPHERE 3400/4400 Series modems with TDM.
For most commands, NMS enables you to specify the destination for the command's results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level:
Abbreviation:
Restrictions:
Routine:
Schedule:
Related Commands: Change Options (cho)
Display Port Speed(s) Input Form
This input form contains the following field:
Device(s) (Required field)
Display Port Speed(s) Results Form
Different results forms are displayed depending on the device to which the command is sent.
Figure 2-43 is a sample of Page 1 of the Display Port Speed(s) results form for a 3400/ 4400 Series
modem. The figures in this form display the port speeds associated with a 19.2 kbps modem.
2-138
Data Technician, Manager, System Administrator
dspsp
Alternate: dsportsp
None
Yes
Yes
Change Port Options (chpo)
Display Port Options (dspo)
Change Port Speed(s) (chpsp)
Enter the device(s) whose port speeds are to be displayed. One or more device(s) may be
specified. Standard addressing format applies to the input. For information on device
addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management
System User's/System Administrator's Guide.
January 1997 6800-A2-GB31-20