Errors - Lexmark MX61 Series Service Manual

Action
Step 3
Check the cable JTDS for proper connection.
Is it properly connected?
Step 4
Check the cable JTDS for damage and pinch points.
Is it free of damage?

133 errors

133 error messages
Error code Description
133.05 CTLS reading above maximum expected value.
133.06 CTLS reading below minimum expected value.
133.08 Excessive CTLS noise.
Unresponsive imaging unit service check
Action
Step 1
a
Check if the imaging unit is a supported and genuine Lexmark
supply. If not, then replace it.
b
Make sure that the imaging unit is properly installed.
c
Make sure that the latest firmware is installed.
Does the problem remain?
Step 2
Check the imaging unit contacts and spring for proper installation
or damage.
Are the contacts and spring properly installed and damaged?
Step 3
Check if the imaging unit contacts and spring are beyond repair.
Are the contacts and spring beyond repair?
Step 4
Straighten the imaging unit contacts and install the spring properly.
Does the problem remain?
Action
Go to "Unresponsive imaging unit service
check" on page
Diagnostic information
139
Yes No
Go to step 4. Reseat the cable.
Replace the Replace the toner
controller board. See density sensor. See
"Controller board "Toner density
removal" on sensor removal" on
page 282. page
139.
Yes No
Go to step 2. The problem is
solved.
Go to step 3. Go to step 5.
Contact the next Go to step 4.
level of support.
Go to step 5. The problem is
solved.
7016
330.