202 Paper Jams - Lexmark MX61 Series Service Manual

202 paper jams

202 paper jam messages
Error code Description
202.01 Exit sensor is covered during warm up.
202.03 Media did not reach the fuser exit sensor.
202.05 Fuser exit sensor covered too long by the current
sheet.
202.07 Fuser exit sensor covered too long by the
previous sheet.
202.13 Restart attempted after an internal jam without
cover open. Close event. Likely that the jam was
not actually cleared.
202.14 Expected banner sheet ( assumed wide ) not
detected by narrow media sensor, possible
accordion jam, unsupported narrow banner
media, or missing signal.
202.16 Page at fuser nip before fuser started ramping
toward desired. Indicates code may be receiving
more hall interrupts than intended.
202.17 Page at fuser nip before fuser reached acceptable
operating temperature. Page arrived at fuser
earlier than expected, so it was probably staged.
202.22 Cartridge Motor - Motor Underspeed Error. Motor
made it to closed loop steady state, but then
detected speed was below threshold.
202.28 Exit sensor bounce issue.
202.32 The sheet is too long to be duplexed. The blow
through is enabled.
202.36 Long paper or shingled multi feed stopped before
sending to duplex.
202.43 During warm up flush, media that passed the input
sensor failed to reach the exit sensor.
202.45 During warm up flush, sheet detected too long
over exit sensor.
Action
Go to
page
Go to
page
Go to
page
Go to
page
Go to
page
Go to
page
Go to
page
Go to
page
Go to
page
Go to
page
Go to
Go to
Go to
page
Go to
page
Diagnostic information
80
"Sensor (fuser exit) jam service check" on
81.
"Sensor (fuser exit) jam service check" on
81.
"Sensor (fuser exit) jam service check" on
81.
"Sensor (fuser exit) jam service check" on
81.
"Sensor (fuser exit) jam service check" on
81.
"Sensor (fuser exit) jam service check" on
81.
"Sensor (fuser exit) jam service check" on
81.
"Sensor (fuser exit) jam service check" on
81.
"Sensor (fuser exit) jam service check" on
81.
"Sensor (fuser exit) jam service check" on
81.
"Duplex service check" on page
"Duplex service check" on page
"Sensor (fuser exit) jam service check" on
81.
"Sensor (fuser exit) jam service check" on
81.
7016
82.
82.