Table of Contents
Advertisement
4
To view and adjust the duplex ADF front side registration, place the quick test page faceup into the ADF.
5
Select Copy Quick Test.
6
After the quick test page copies, select ADF Front.
7
Use the plus to increase or the minus to decrease the settings value for horizontal adjust and top margin.
Note: Each button press moves the margin values one pixel in the respective direction.
8
Select Submit to accept the value.
9
Save changes by placing the print quick test page face up and selecting Copy Quick Test.
10
Repeat steps 6, 7, and 8 as needed.
11
To view and adjust the duplex ADF backside registration, place the quick test page face down up into the
ADF, and select Copy Quick Test.
12
After the quick test page copies, select ADF Back.
13
Use the plus or minus to increase or decrease the settings value for horizontal adjust and top margin.
Note: Each button press moves the margin values one pixel in the respective direction.
14
Select Submit to accept the value.
15
Verify the changes by placing the print quick test page face down and selecting Copy Quick Test.
16
Repeat steps 13, 14, and 15 as needed.
To manually register the flatbed, perform the following steps:
1
In the Configuration Menu, select the Scanner Manual Registration menu item.
2
Select the Print Quick Test Page menu item.
3
To view and adjust the flatbed registration, place the quick test page into the flatbed.
4
Select the Copy Quick Test Page item.
5
After the quick test page copies, select Flatbed.
6
Use the plus or minus to increase or decrease the settings value for the left or top margin.
Note: Each button press moves the margin values one pixel in the respective direction.
7
Select Submit to accept the value.
8
Place the print quick test page on the flatbed and select Copy Quick Test.
9
Repeat steps 5 and 6 as needed.
10
To exit REGISTRATION, select Back or Stop.
Service menus
228
7016
Advertisement
Table of Contents
