Lexmark MX61 Series Service Manual page 104

Stapler carriage jam service check
Action
Step 1
Open the stapler service cover. Reseat the sensor (stapler throat)
cable. Then reseat also the other end of the cable on the controller
card, and then POR the machine.
Does the error remain?
Step 2
Open the stapler right cover. Reseat the stapler carriage assembly
cables. Then reseat also the other end of the cables on the
controller card, and then POR the machine.
Does the error remain?
Step 3
Enter Diagnostic mode and navigate to:
FINISHER TESTS > Staple Test
Does the error remain?
Step 4
Check the stapler interface cable. If damaged, then replace the
cable. See "Stapler interface cable removal" on page
Reseat the interface cable on the controller card, and then POR
the machine.
Does the error remain?
Step 5
Reseat all connectors on the controller card, and then POR the
machine.
Does the error remain?
403.
Diagnostic information
104
Yes No
Replace the stapler The problem is
accumulator solved.
assembly. See
"Stapler
accumulator
assembly removal"
on page 422.
POR the machine. If
the error persists,
then go to step 2.
Go to step 3. The problem is
solved.
Replace the stapler The problem is
carriage assembly. solved.
See "Stapler
carriage assembly
removal" on
page 387.
POR the machine. If
the error persists,
then go to step 4.
Go to step 5. The problem is
solved.
Replace the stapler The problem is
controller card. See solved.
"Stapler controller
card removal" on
page 397.
7016