Lexmark MX61 Series Service Manual page 74

Error code Description
200.11 Printhead motor fell out of lock after page reaches
the input sensor.
Mirror motor got locked, and then lost it again
before the initial lock timeout.
200.12 Printhead was not ready for media.
200.13 Media at input sensor is not the next media to be
imaged.
200.14 Media reached the input sensor before EP was
ready.
200.15 Image data did not start on time.
200.16 Fuser motor stalled.
200.19 Page that was successfully picked from option tray
never reached the input sensor.
200.21 No response from paper port driver while waiting
for the source to deactivate the Input Source
Ready flag to indicate it has initiated picking.
200.23 Laser servo never started due to potential conflict
with the transfer servo.
200.24 Measured gap at input sensor too small to meet
video delivery requirements. (Not enough time
since prior image finished to start new image).
200.29 Printhead drive control out of range due to an
external event beyond what the control is
designed to handle.
200.30 Invalid printhead NVRAM.
200.31 Paper, in the middle of a job, at input sensor before
interrupt occurred.
200.32 Detected cover switch bounce.
Printhead lost HSYNCs due to a glitch with the
laser safety interlock, for example, bouncy cover
switch.
200.33 Input sensor covered too quickly.
200.38 Interpage servo gap smaller than expected for
galvo offset target evaluation.
200.42 Rogue sheet at ACM sensor while flushing the
paper path prior to declaring Tray 1 source empty.
Action
Go to
on page
Go to
on page
Go to
on page
Go to
on page
Go to
on page
Go to
on page
Go to
check" on page
Go to
check" on page
Go to
check" on page
Go to
on page
Go to
on page
Go to
on page
Go to
on page
Go to
check" on page
Go to
check" on page
Go to
on page
Go to
check" on page
Go to
check" on page
Go to
check" on page
Diagnostic information
74
"Sensor (input) image jam service check"
77.
"Laser scanning unit (LSU) service check"
134.
"Sensor (input) image jam service check"
77.
"Sensor (input) image jam service check"
77.
"Sensor (input) image jam service check"
77.
"Sensor (input) image jam service check"
77.
"Main drive motor control jam service
78.
"Sensor (input) early/late arriving service
76.
"Sensor (input) early/late arriving service
76.
"Sensor (input) image jam service check"
77.
"Sensor (input) image jam service check"
77.
"Sensor (input) image jam service check"
77.
"Sensor (input) image jam service check"
77.
"Sensor (input) early/late arriving service
76.
"Sensor (input) early/late arriving service
76.
"Laser scanning unit (LSU) service check"
134.
"Sensor (input) early/late arriving service
76.
"Sensor (input) early/late arriving service
76.
"Sensor (input) early/late arriving service
76.
7016