Periodic Maintenance; Tools Required For Inspection; Periodic Inspection - Delta AH Motion Series Hardware Manual

AH Mo t io n – H ar d war e M a nu a l

5.3 Periodic Maintenance

Under the condition that the daily inspection is undertaken, users are suggested that they should carry out the periodic
maintenance according to the actual operating environment. After making sure that the ambient environment and the AH
Motion system conform to the cautions listed in section 5.1, users then can undertake the periodic inspection described
below. If any abnormal situation occurs, please follow the suggested actions and carry out the maintenance.

5.3.1 Tools Required for Inspection

 A screwdriver
 Industrial alcohol
 A clean cotton cloth
 A multimeter
 A thermometer
 A hygrometer

5.3.2 Periodic Inspection

No. Item
Ambient
temperature/hu
midity
1
_5
Atmosphere
2 Supply voltage
Looseness
3
Adhesion of dirt
Looseness of
terminal screws
4
Looseness of
connectors
5 PLC system diagnosis Check the error logs.
5 - 4
Inspection
The ambient temperature and
the ambient humidity are
measured by a thermometer
and a hygrometer.
Measure corrosive gas.
Measure the AC power
supply.
Check whether the module is
loose.
Check the appearance.
Tighten the screws with a
screwdriver.
Pull the connectors.
Criterion
The ambient temperature and the
ambient humidity must conform
to the specifications for the
modules or the backplane. If the
specifications are different, the
strictest specifications have high
priority.
Corrosive gas must not be
present.
The power supply should meet
the specifications for the power
supply module.
The module must be installed
firmly.
Dirt must not be present.
The screws must not be loose.
The connectors must not be
loose.
No new error occurs.
Action
To ensure that the
system operates in a
stable environment,
check the reason why
the environment
varies, and correct it.
Check the power
supply.
Please refer to
chapter 4 for more
information about
installing the module.
Remove the dirt.
Further tighten the
screws.
Further tighten the
screws on the
connectors.
Please refer to AH
Motion – Operation
Manual for more
information regarding
troubleshooting and
error logs.