Tools Required For Inspection; Daily Inspection - Delta AH Motion Series Hardware Manual

5.2.1 Tools Required for Inspection

 A screwdriver
 Industrial alcohol
 A clean cotton cloth

5.2.2 Daily Inspection

No. Item
1 Appearance
Installation of a
2
backplane
Installation of a
3
module
4 Connection
Power POWER
supply LED
module indicator
RUN LED
indicator
ERROR
LED
indicator
CPU
5
BUS
module
FAULT
LED
indicator
SYSTEM
LED
indicator
LED indicators on an
extension module
* Please refer to AH500 Module Manual for more information related to the LED indicators on the extension modules.
Inspection
Visual inspection
Check whether the set screws
are loose.
Check whether the backplane is
installed on the DIN rail
properly.
Check whether the module is
loose, the projection is inserted
into the hole on the backplane,
and the screw is tightened.
Check whether the removable
terminal block is loose.
Check whether the connector is
loose.
Check whether the POWER
LED indicator is ON.
When the CPU module is
running, check whether the
RUN LED is ON.
Check whether the ERROR
LED indicator is OFF.
Check whether the BUS FAULT
LED indicator is OFF.
Check whether the SYSTEM
LED indicator is OFF.
Check whether the LED
indicators on the extension
module are ON.
Ch a pt er 5 M ai n te n an c e an d I ns p ec t i o n
Criterion
Dirt must not be present.
The backplane must be
installed firmly.
The hook under the
module must be inserted
into the hole in the
backplane, and the screw
must be tightened.
The removable terminal
block should be tight.
The connector should be
tight.
The POWER LED
indicator must be ON.
The RUN LED indicator
must be ON.
The ERROR LED indicator
must be OFF.
The BUS FAULT LED
indicator must be OFF.
The SYSTEM LED
indicator must be OFF.
If the LED indicators are
ON, the module operates
normally.
Corrective Action
Remove the dirt.
Further tighten the screws.
Install the backplane on
the DIN rail properly.
Install the module firmly.
Install the terminal block
firmly.
Further tighten the screws
on the connector.
Please refer to AH
Motion – Operation
Manual for more
information regarding
troubleshooting and error
logs.
5 - 3
5_