Configuring The Administrator Settings; Administrator Tab; Reset Settings Tab - Ricoh 132 MF User Manual

8. Configuring the Machine Using Utilities

Configuring the Administrator Settings

Click [Administrator Tools] to display the page for configuring the administrator settings.
This page contains the following tabs: [Administrator], [Reset Settings], [Backup Setting], [Restore
Setting], [Set Date/Time], [Energy Saver Mode], and [PCL6 Mode].

Administrator Tab

Administrator Settings
Item
Change Password
New Password
Confirm New Password Enter the same password again, to confirm.
Change E-mail Address Check this to configure the administrator e-mail address.
Administrator E-mail
Address
• To change the password, it is necessary to enter the current password.
• The password must be specified during the Initial Setup, which is required after turning on the
machine for the first time. For details, see Setup Guide. Note that the password is cleared when the
settings are reset.

Reset Settings Tab

Reset Settings
Item
Reset Network Settings
Reset Menu Settings
302
Check this to configure the administrator password.
Enter the new administrator password. Can contain up to 16 characters.
Enter the administrator e-mail address.
If the machine's e-mail address is not configured in the [SMTP] page, this
address will be used as the sender's address of e-mails sent from this
machine, such as notification e-mails and Internet Faxes. Can contain up to
64 characters.
Select to clear the settings configured under the [Network Settings].
Select to clear the settings that are not related to the network to their
defaults.
Description
Description