Ricoh 132 MF User Manual page 331

Message
Low voltg stopped The supplied voltage is too low
print to run the machine's functions.
Memory Overflow The number of fax jobs in
memory (unsent or unprinted
faxes) has reached maximum,
so new jobs cannot be stored.
Memory Overflow The data is too large or
complex to print.
Memory Overflow
Misfeed: Duplex Unit Paper has been jammed in the
duplex unit.
Remove Paper
Misfeed: BypassTray Paper has been jammed in the
bypass tray.
Misfeed: Standard Paper has been jammed in the
Tray paper exit area.
Misfeed: Tray 1 Paper has been jammed in the
tray 1 paper input area.
Causes
• The machine's memory
reached capacity while
scanning the first page of
the original to store a fax
job in memory before
transmission.
• The machine's memory
reached capacity while
storing a fax in memory in
Memory Transmission
mode.
Error and Status Messages on the Screen
Solutions
Check the power source. If devices that
consume much electricity, such as halogen
heaters or electric heaters, are connected
to the same outlet as the machine, plug
them into separate outlets.
Wait until pending jobs have been
transmitted or printed.
• Select [600 × 600 dpi] in
[Resolution] under [Printer Features]
to reduce the size of data. See
page 232 "Printer Features Settings".
• If using the PCL6 printer driver, set
[Resolution] in the [Print Quality] tab
to [600 × 600 dpi].
Resend the fax in parts as several smaller
individual faxes, or send at a lower
resolution.
Remove the jammed paper. See
page 336 "Removing Paper Jams".
Remove the jammed paper. See
page 336 "Removing Paper Jams".
Remove the jammed paper. See
page 336 "Removing Paper Jams".
Remove the jammed paper. See
page 336 "Removing Paper Jams".
329