Ricoh 132 MF User Manual page 332

10. Troubleshooting
Message
Misfeed: Tray 2
Net Communication
Error
Network is not Ready A scanned file could not be sent
On Hook or Stop key The machine has been off-hook
Out of Paper: X
Please Restart the
Machine
Printing stopped due
to low voltage.
Replace Required
Soon:Print Cartr.
Replacement
Required: Print Cartr.
RX Communication
Error
Scan (NW)
Disconnected
330
Causes
Paper has been jammed in the
paper tray.
Connection with the server was
lost while sending or receiving
data.
because the machine has not
received IP address information
from the DHCP server
completely.
for an extended period of time.
The indicated tray has run out of
paper.
The machine needs to be
restarted.
The supplied voltage is too low
to run the machine's functions.
The print cartridge is almost
empty.
The print cartridge is almost
empty.
The machine has run out of
toner.
A reception error occurred, and
the fax could not be received
correctly.
A scanned file could not be sent
because the Ethernet cable was
not connected properly.
Solutions
Remove the jammed paper. See
page 336 "Removing Paper Jams".
Contact the network administrator.
Wait until the machine receives the IP
address information completely, and then
try the operation again.
Put down the handset phone or press the
[Clear/Stop] key.
Load paper to the indicated tray. See
page 44 "Loading Paper".
Turn off the power, and then turn it back
on.
Check the power source. If devices that
consume much electricity, such as halogen
heaters or electric heaters, are connected
to the same outlet as the machine, plug
them into separate outlets.
Prepare a new print cartridge.
Replace the print cartridge. See page 313
"Replacing the Print Cartridge".
If possible, contact the sender of the fax
and ask them to resend it.
Reconnect the Ethernet cable properly,
and then try the operation again.