Table of Contents
Advertisement
3-14 Removing covers and grilles
Procedure 3-7
Removing the breaker interface panel cover
Use this procedure to remove the cover from the NT4K14 BIP in the modular
business package (MBP) master cabinet. Other procedures in this document
call upon this procedure.
Action
Step
1
AccessNode P0904244 Issue 1.0
Action
Use a 1/4-inch slot screwdriver to turn the left and right locking screws, until
the dots are no longer aligned, then pull on the cover latches to remove the
cover. See Figure 3-7.
CAUTION
Damage to locking screws and the finish of the
equipment covers
Do not use a coin to turn the locking screws on the
equipment covers, as it may damage the locking screws
and the finish on the covers. Only use a 1/4 in. slot
screwdriver to turn the locking screws.
—continued—
Advertisement
Table of Contents
