Table of Contents
Advertisement
3-10 Removing covers and grilles
Procedure 3-5
Removing separator bars
Use this procedure to remove the separator bars from the front or rear of
modular business package (MBP) master or expansion cabinets.
Requirements
The following tools and materials are required:
•
Action
Step
1
2
3
AccessNode P0904244 Issue 1.0
sheets of cardboard or foam on which to rest the separator bar while the
installation is being performed
Action
Grasp the left and right ends of the separator bar, as shown in Figure 3-5.
Lift the separator bar vertically to disengage the guide pins from the cabinet
and remove the bar from the cabinet.
Note: It may be necessary to bump the underside of the bar with your fist to
disengage it from the cabinet.
Store the separator bar on cardboard or foam to protect its finish while you
perform the installation.
—continued—
Advertisement
Table of Contents
