4 Opening And Closing The Unit; Removing And Attaching The Rear Panel; Remove The Rear Panel; Attaching The Rear Panel - Henny Penny FSHN610 Service Instructions Manual

Opening and closing the unit
4 Opening and closing the unit

4.1 Removing and attaching the rear panel

4.1.1 Remove the rear panel.

4.1.2 Attaching the rear panel

NOTICE
10
A
Image: Remove the rear panel, A Tabletop unit, B Built-in unit
1. Unscrew the screws in the back wall.
2. Holding the bottom edge, carefully pull the back wall down and then
forward.
Risk of property damage from leaky housing
• Check seals when attaching the housing parts.
• Replace damaged seals.
1. Slide the back wall up.
2. Install screws in the back wall.
The back wall must be in contact with the unit on all sides.
Service-instructions
B