Default Setup; To Install The Fan Safety Shield - Agilent Technologies 54845B Manual

Default Setup

A Default Setup is provided to assure the instrument setup is in a known default state.
The default setup prevents previous setups from interfering with the next test. It also
simplifies the instrument setup procedure. Use the default setup when a procedure
requires it.
• Press the Default Setup key to set the instrument to the default state.

To install the fan safety shield

Disconnect the instrument power cord and remove the cover.
1
If necessary, refer to the procedures in chapter 6 "Replacing Assemblies".
Clip the fan safety shield over the outside of the instrument chassis next to the fans.
2
See figure 5-1.
Figure 5-1
Installing the Fan Safety Shield
Chapter 5: Troubleshooting

To install the fan safety shield

5–3