Agilent Technologies 54845B Manual page 102

Chapter 5: Troubleshooting
To Configure the motherboard jumpers and setup BIOS
Configure the MOT VP-22 motherboard for the 866 MHz CPU, CDROM, and 120 Mbyte
floppy drive.
There is only one jumper to configure on the MOT VP-22 motherboard. It is JP1 and is located
at the bottom of the board by the fourth PCI slot. JP1 must be jumpered between 1 and 2. The
test of the configuration settings are automatically handled by the motherboard, except for the
BIOS settings.
Configure the MOT series VP-22 Motherboard BIOS parameters.
Use this procedure to set the MOT VP-22 motherboard BIOS.
Connect the power cable to the Infiniium oscilloscope.
1
Connect the external keyboard to the rear panel.
2
Press the delete key when you see the following prompt on the bottom of the screen
3
Press TAB to Show POST screen, DEL to enter SETUP, F12 to select boot device.
Note: If you are not seeing the prompt, or the oscilloscope does not appear to be functioning,
check the motherboard jumper setting, and the ribbon cable connectors. Otherwise, continue
with the next step.
5–24