Agilent Technologies 54845B Manual page 32

Chapter 2: Preparing for Use
To connect oscilloscope probes
To disconnect the probe, push the small latch on top of the probe connector to the left,
3
then pull the connector body away from the front panel of the oscilloscope without
twisting it.
CA UT IO N
AVOID DAMAGE TO THE PROBE CONNECTOR!
Do not attempt to twist the snap-on probes on or off the oscilloscope's BNC connector. Twisting
the probe connector body will damage it.
CA UT IO N
DO NOT EXCEED THE MAXIMUM INPUT VOLTAGE!
Do not exceed the maximum input voltage rating of the oscilloscope inputs! The maximum input
voltage for 50-Ω inputs is 5 V
(dc+ac) [ac < 10 kHz], CAT I. (Probes may have different ratings. See the probe documentation.)
2–8
, CAT I. The maximum input voltage for 1 MΩ inputs is ±100V
rms