Agilent Technologies 54845B Manual page 126

Chapter 6: Replacing Assemblies
To remove and replace the front panel assembly
Disconnect the Aux Out SMB cable W9 from J10 and the black Comp wire W10 from
4
J4. Push them to the side. If necessary, use pliars to remove the Comp wire.
These cables are located behind the Aux Trigger Input BNC connector on the Acquisition board.
Figure 6-13
SMB Cable W9 and Comp Wire W10
Disconnect the backlight primary cable W21, flat-panel display driver cable W11, and
5
keyboard cable W12.
Figure 6-14
Disconnecting W21 Backlight Primary Cable, W11 Display Driver Cable, and W12 Keyboard Cable
6–12