Replacement Procedure
Replacement Procedure for E5092A-020
Power Supply Assembly Removal
Tools Required
•
Procedure
Refer to Figure 5-5 for this procedure.
Step 1. Remove the outer cover as described in "Outer Cover Removal" on page 178.
Step 2. Remove the A1 switch control board as described in "A1 Switch Control Board Removal"
on page 181.
Step 3. Disconnect the two power cable (item 1).
Step 4. Remove the four TORX T10 screw (item 2) from the bottom.
Step 5. Remove the power supply board from the chassis.
Figure 5-5
Power Supply Assembly Removal
182
TORX screwdriver, T10, T15 and T20.
Chapter 5