Measuring Access Probe Power - Agilent Technologies 8960 Series Operation Manual

cdma2000 Measurement Procedures

Measuring Access Probe Power

1. Press the
CALL SETUP
2. Press the End Call key (
3. Select the Access Probe Power measurement (see
page 48).
4. Press the Register Mobile key (
NOTE The remainder of this procedure lists the steps required to make access
probe power measurements using call limit mode. Call limit mode
provides testing of complete access probe sequences during a call
origination.
5. Set up the measurement parameters as needed for your measurement situation
(see "B. Set up the measurement." on page
6. Press the key on the lower left side of the display (Call Control) until 2 of 2 is
More
displayed. Press the Cell Info key (
Parameters key.
7. Turn the Timer Based Registration State off.
8. Press the
MEASUREMENT
9. Press the key on the lower right side of the display (Call Parms) until 2 of 3 is
More
displayed. Press the Call Limit Mode key (
74
S:\Hp8960\Generic Documents\Manual Operation
key.
).
F3
). A typical display is shown below.
F6
F2
key.
Getting Started Guide\Pi_manual operation getting started
"B. Select measurements." on
50).
) key, then the Registration
) key and turn call limiting on.
F9
guide\chapters\cdma2000_gen_op_overview_man_measurements.fm