Table of Contents
Advertisement
Expansion cards and backup units
Installing the new expansion card
▶ If applicable, install the slot bracket, see
page
172.
▶ Install the expansion card, see
Concluding steps
▶ For slot 3, 4, 5, 6 and 7: Install the corresponding riser module, see
"Handling riser modules" on page
▶
"Reassembling" on page
▶ If applicable, connect external cables to the expansion card.
▶
"Connecting the power cord (AC PSU)" on page
▶
"Switching on the server" on page
▶
"Enabling replaced components in the BIOS" on page
▶ Inform the customer about changed WWN, MAC and SAS addresses, see
"Basic information" on page
▶
"Updating the NIC configuration file in a Linux and VMware environment" on
page
107.
▶
"Updating expansion card firmware" on page
▶ If applicable,
"Enabling the boot watchdog" on page
▶
"Resuming BitLocker functionality" on page
▶ If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
Configuration of network settings should be performed by the
customer. For more information, see
recovery" on page
▶ If applicable, restore LAN teaming configurations, see
upgrading LAN controllers" on page
212
"Installing the expansion card" on page
60.
53.
59.
110.
211.
117.
Upgrade and Maintenance Manual
"Installing a slot bracket" on
58.
102.
93.
101.
108.
"Note on network settings
"After replacing or
192.
RX4770 M5
Advertisement
Table of Contents
