Fujitsu PRIMERGY RX4770 M5 Upgrade And Maintenance Manual page 151

▶ Wait about 30 seconds.
This period is necessary for the RAID controller to recognize that an
HDD module has been removed and for the HDD to come to a stop.
This period is necessary for the RAID controller to recognize that an
SSD module has been removed.
▶ Pull the HDD/SSD module completely out of its bay.
Installing a 2.5-inch HDD/SSD dummy module
CAUTION
▶
If the removed HDD/SSD module is not replaced immediately,
always replace a dummy module into the unused HDD/SSD bay to
comply with applicable EMC regulations and satisfy cooling
requirements.
Figure 60: Installing the dummy module
▶ Push the dummy module into the empty bay until it engages.
Concluding steps
▶ No steps needed.
RX4770 M5
Hard disk drive (HDD) / solid state disk (SSD)
Upgrade and Maintenance Manual 151