Table of Contents
Advertisement
Installing the new riser card
Figure 112: Installing the riser card - example: riser module 3/4
▶ Install the new riser card on the riser module so that the three studs on the
riser holder floor align with the screw holes of the riser card.
Riser module 3/4 and 6/7 use the same riser card model.
▶ Fasten the riser card on the upper side with two screws (see circles).
▶ Only for riser module 3/4 and 6/7: Fasten the riser card on the rear side with
one screw (see close up).
▶ Install the expansion card, see
RX4770 M5
Expansion cards and backup units
"Installing the expansion card" on page
Upgrade and Maintenance Manual
192.
215
Advertisement
Table of Contents
