Table of Contents
Advertisement
– Phillips PH1 / (+) No. 1 screw driver
Tools:
– Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Locating the defective server" on page
▶
"Suspending BitLocker functionality" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Extending the server out of the rack" on page
▶
"Removing the server from the rack" on page
▶
"Removing the top covers" on page
▶ Remove the air duct from the top system board, see
air duct" on page
▶
"Removing the fan cage" on page
▶
"Removing the riser module 3/4 and 6/7" on page
▶
"Removing the top system board holder" on page
▶ Remove the air duct from the bottom system board, see
CPU air duct" on page
▶ Disconnect the mini-SAS cable near the power distribution board from the
bottom system board.
▶ If applicable, remove the RAID card, see
page
209.
▶ Remove the riser module in slot 5, see
page
64.
▶ Disconnect the VGA cable from the bottom system board, see
the front panel module" on page
▶ Remove all hot-plug PSUs, see
RX4770 M5
72.
69.
72.
305.
"Removing a hot-plug PSU" on page
Upgrade and Maintenance Manual
Power supply unit (PSU)
43.
85.
45.
46.
48.
49.
51.
"Removing the CPU
61.
74.
"Removing an expansion card" on
"Removing the riser module" on
"Removing the
"Removing
125.
131
Advertisement
Table of Contents
