Olivetti d-Copia 3001MF Service Manual page 218

8. Loop the outer ends of the scanner wires around the outer grooves in the pulleys on the mirror 2 frame,
winding from below to above. .......................................................................................................................... (1)
9. Hook the round terminals onto the catches inside the scanner unit. ............................................................... (2)
10. Loop the inner ends of the scanner wires around the grooves in the pulleys at the left of the scanner unit,
winding from below to above. .......................................................................................................................... (3)
11. Loop the scanner wires around the inner grooves in the pulleys on the mirror 2 frame, winding from
above to below................................................................................................................................................. (4)
12. Wind the scanner wires around the grooves in the scanner wire guides at the left of the scanner unit. ......... (5)
13. Hook the round terminals onto the scanner wire springs................................................................................. (6)
14. Remove the two scanner wire stoppers and
frame securing tools.
15. Focusing on the locating ball of the wire
drum, move aside the wires to inside.
16. Move the mirror 2 frame from side to side to
correctly locate the wires in position.
17. Refit the mirror 1 frame.
18. Move the mirror 1 and 2 frames to the
machine left, and insert the two frame secur-
ing tools into the positioning holes at the
front and rear of the scanner unit to secure
the frames in position.
19. Hold the wires and fix each front and rear
wire holder plate to mirror 1 frame with the
screw.
20. Remove the two frame securing tools.
21. Refit all the removed parts.
Y112040-6
Figure 1-5-42
Frame securing tool
Service Manual
Frame securing tool
Mirror 1 frame
Mirror 2 frame
Figure 1-5-43
2K5
1-5-23