Olivetti d-Copia 3001MF Service Manual page 174

Code
C8210 Stapler problem (optional document
finisher)
Jam 82 is indicated.
Finisher stapler problem (optional
built-in finisher)
The stapler home position sensor does
not change state from nondetection to
detection within 200 ms of the start of
stapler motor counterclockwise (forward)
rotation.
During initialization, the stapler home
position sensor does not change state
from non-detection to detection within
600 ms of the start of stapler motor
clockwise (reverse) rotation.
C8320 Adjustment motor 2 problem
(optional document finisher)
The adjustment sensor 2 does not turn
on/off within specified time of the adjust-
ment motor 2 turning on.
C8330 Adjustment motor 1 problem
(optional document finisher)
The adjustment sensor 1 does not turn
on/off within specified time of the adjust-
ment motor 1 turning on.
Y112040-6
Contents
Causes Check procedures/corrective measures
The stapler con- Reinsert the connector. Also check for conti-
nector makes poor nuity within the connector cable. If none,
contact. remedy or replace the cable.
The stapler is Remove the stapler cartridge, and check the
blocked with a sta- cartridge and the stapling section of the sta-
ple. pler.
The stapler is bro- Replace the stapler and check for correct
ken. operation.
Defective finisher Replace the finisher main PWB and check
main PWB. for correct operation.
The stapler con- Reinsert the connector. Also check for conti-
nector makes poor nuity within the connector cable. If none,
contact. remedy or replace the cable.
The stapler is Remove the stapler cartridge, and check the
blocked with a sta- cartridge and the stapling section of the sta-
ple. pler.
The stapler is bro- Replace the front stapler and check for cor-
ken. rect operation.
Defective finisher Replace the finisher control PWB and check
control PWB. for correct operation.
The adjustment Reinsert the connector. Also check for conti-
sensor 2, adjust- nuity within the connector cable. If none,
ment motor 2 con- remedy or replace the cable.
nector makes poor
contact.
Defective adjust- Replace the adjustment sensor 2.
ment sensor 2.
Defective adjust- Replace the adjustment motor 2.
ment motor 2.
Defective finisher Replace the finisher main PWB and check
main PWB. for correct operation.
The adjustment Reinsert the connector. Also check for conti-
sensor 1, adjust- nuity within the connector cable. If none,
ment motor 1 con- remedy or replace the cable.
nector makes poor
contact.
Defective adjust- Replace the adjustment sensor 1.
ment sensor 1.
Defective adjust- Replace the adjustment motor 1.
ment motor 1.
Defective finisher Replace the finisher main PWB and check
main PWB. for correct operation.
Service Manual
Remarks
2K5
1-4-31