Door Adjustment; Installing Splashguard Brackets; Case Joining - Hussmann INSIGHT REACH-IN Installation & Operation Manual

DOOR ADJUSTMENT

After leveling and joining the merchandisers, adjust and level doors
according to the accompanying door manual for this case. Factory
settings may be lost due to vibration during shipment.

INSTALLING SPLASHGUARD BRACKETS

INSTALLING
SPLASH GUARD BRACKETS
1. Attach bumper retainer and splashguard support bracket using two
screws per bracket.
2. Install splashguard support brackets underneath case. The leveling
brackets have a maximum extension of one (1) inch (25 mm) for
uneven floors.
Do not place shims under splashguard brackets.
NOTE
Install splashguard support brackets before piping case.
INSTALLING
SPLASH GUARD BRACKETS
Screw Screw
Bumper
Bumper
Retainer
Retainer
HUSSMANN CORPORATION • U.S. & CANADA 1-800-922-1919 • BRIDGETON, MO 63044-2483 • MEXICO 1-800-890-2900 • WWW.HUSSMANN.COM • PN 3181178_A
Screw
Bracket Support
Splasguard
Bumper
Retainer
Splashguard Bracket Support
Splasguard
Support Bracket

CASE JOINING

Sectional construction means that two or more merchandisers may be
joined in line, yielding one long continuous display requiring only one
pair of ends. Cases are joined from left to right. Start joining the right
end to the left end of each merchandiser in the lineup.
To join like fixtures, a joining kit is required. To join merchandisers
operating at different temperatures, a partition kit is needed. A
partition kit is required to join the same temperature merchandisers
that are on different defrost cycles.
All joints must be air-tight to prevent the formation of ice or
condensation.
Refer to the joining instructions on the next page.
Bumper
Bumper
Retainer
Retainer
1-3