Table of Contents
Advertisement
CASE CLEARANCE
A 4-inch (102 mm) space between the rear of the merchandiser and
wall must be maintained for air circulation. However, in high ambient
conditions, sweating may still occur. If this happens, install a method of
forced ventilation such as a fan ventilation kit.
ATTENTION
•
Merchandiser must operate for 24 hours before
loading product!
•
Regularly check merchandiser temperatures.
•
Do not break the cold chain. Keep products in freezer
or cooler before loading into merchandiser.
•
Medium temperature merchandisers are designed for
loading ONLY pre-chilled products.
•
Low temperature merchandisers are designed for
loading ONLY frozen products.
» Excessive ambient conditions may cause condensation and therefore sweating of doors. Facility operators should
monitor doors and floor conditions to ensure safety of persons.
» Case ventilation openings must be clear of any obstructions. Do not damage the refrigerant circuit.
» Always disconnect the electrical power at the main disconnect when servicing or replacing any electrical component.
This includes, but is not limited to, such items as fans, heaters, thermostats, and lights.
» Do not use mechanical devices or other means to accelerate the defrosting process.
» Do not use electrical appliances inside the food storage compartments of the case(s).
» Do not store items or flammable materials atop the unit. Do not walk on case.
HUSSMANN CORPORATION • U.S. & CANADA 1-800-922-1919 • BRIDGETON, MO 63044-2483 • MEXICO 1-800-890-2900 • WWW.HUSSMANN.COM • PN 3181178_A
Providing Information About Safety Messages in Collateral Materials and Product
INSTALLATION TOOL LIST
Unloading From Trailer:
Lever Bar (also known as a Mule, Johnson Bar, J-bar,
Lever Dolly, and pry lever)
A1
Explanation of Signal Words and Symbols
Moving Dolly
Signal words and safety symbols that are used in a product's collateral materials or on the product may
be defined in collateral materials if space is available.
Setting Case Line-Up:
A1.1
Safety Alert Symbol
Level, 4 ft suggested
Ratchet
The meaning of the safety alert symbol may be provided in collateral materials. The following artwork may
be used for this purpose.
¼-inch Socket
/
-inch Socket
5
16
½-inch Socket
This is the safety alert symbol. It is used to alert you
Battery Drill / Screw Gun
to potential physical injury hazards. Obey all safety
Caulking Gun
messages that follow this symbol to avoid possible
10-inch Adjustable Crescent Wrench
injury or death.
REVISION HISTORY
A1.2
Signal Words
The meaning of the different signal words as defined by the ANSI Z535.6 and ANSI Z535.4 standards
REVISION A — April 2023 - Original Issue
may be explained in collateral materials. The following artwork may be used for this purpose.
A1.3
Other Highlighting Conventions
The meaning of any other highlighting conventions used to differentiate safety messages (e.g., text
manipulations, indention, etc.) may be explained in collateral materials.
A1.4
Safety Symbols
The meaning of any safety symbols used on safety labels or collateral materials may be explained in
collateral materials.
Iv
© 2017 National Electrical Manufacturers Association
Safety Signs and Labels
(Informative)
DANGER indicates a hazardous situation which, if not
avoided, will result in death or serious injury.
WARNING indicates a hazardous situation which, if not
avoided, could result in death or serious injury.
CAUTION indicates a hazardous situation which, if not
avoided, could result in minor or moderate injury.
NOTICE is used to address practices not related to
physical injury.
Safety instructions (or equivalent) signs indicate specific
safety-related instructions or procedures.
Advertisement
Table of Contents
Troubleshooting
