Exterior Loading; Merchandisers Shipped With End Installed; Shipping Braces; Level Case And Place Shims - Hussmann INSIGHT REACH-IN Installation & Operation Manual

EXTERIOR LOADING

Do not walk on top of merchandisers or damage to the merchandisers
and serious personal injury could occur. They are not structurally
designed to support excessive external loading such as the weight of a
person. Do not store items or flammable materials atop the unit.

MERCHANDISERS SHIPPED WITH END INSTALLED

If the case was shipped with the end installed, two long bolts were
used to hold the shipping brace to the end. If the shipping bolts are
reinserted after removing the brace, they will extend into the product
area and may damage the coil. Therefore, be sure to replace these
bolts with the shorter bolts provided.
Be careful not to damage the factory-installed end while moving the
merchandiser. Make sure that tools are positioned past the end and
beneath the merchandiser's support bar.

SHIPPING BRACES

Move the merchandiser as close as possible to its permanent location
and then remove all packaging. Check for damage before discarding
packaging. Remove all separately packed accessories such as kits and
shelves.
BOTTOM VIEW
view from underneath 5-door case
Shim
Location
HUSSMANN CORPORATION • U.S. & CANADA 1-800-922-1919 • BRIDGETON, MO 63044-2483 • MEXICO 1-800-890-2900 • WWW.HUSSMANN.COM • PN 3181178_A

LEVEL CASE AND PLACE SHIMS

Begin lineup leveling from the highest point of the store floor.
Merchandisers must be installed level to ensure proper operation of the
refrigeration system and to ensure proper drainage of defrost water.
When leveling merchandisers, use a carpenter's level.
Place shims under the rail and make sure that they are positioned at a
base component (crossbar). This transfers the weight directly from the
loaded case through to the floor. Placing shims at other locations will
cause uneven distribution of weight leading to piping leaks, as well as
sagging or wracked doors. Bottom front supports must be shimmed if
not in full contact with the floor.
INSTALLATION
Approximately
Centered
1-2
A1.2
The meaning of the different signal words as defined by
may be explained in collateral materials. The following
A1.3
Approximately
The meaning of any other highlighting conventions use
centered
manipulations, indention, etc.) may be explained in coll
A1.4
The meaning of any safety symbols used on safety labe
collateral materials.
Base Component
Copyright National Electrical Manufacturers Association
Provided by IHS Markit under license with NEMA
No reproduction or networking permitted without license from IHS
Rear of Case
Base Component
Base Component
Shim Here
Shim Here
Shim Here
Shim Here
This is the safety
to potential physi
messages that fo
injury or death.
Signal Words
DANGER in
avoided
WARNING i
avoided
CAUTION in
avoided
NOTICE is u
physical
Safety instru
It is the installing contractor's
safety-re
responsibility to consult
local agencies for local code
requirements.
Other Highlighting Conventions
Safety Symbols
© 2017 National Electrical M
Base
Component
Shim Here
Shim Here
Lice
Not