Table of Contents
Advertisement
InstALLAtIon
1-6
DOOR ADJUSTMENT
After leveling and joining the merchandisers,
adjust and level doors according to manufacturer's
instructions shipped with each product. Factory
settings may be lost due to vibration during
shipment.
JOINING
Sectional construction means that two or more
merchandisers may be joined in line yielding
one long continuous display requiring only one
pair of ends. Joining kits and instructions are
shipped with each merchandiser.
To join merchandisers with independent ends,
a joining kit is required.
The painted caps for the end assembly bolt
holes may be kept with this manual. Insert two
insulating plugs into each bolt hole of the ends
to be joined. After leveling and aligning the top
edge of the ends, install the two case-to-case
brackets on to the top with sheet metal screws as
shown below.
To join unlike fixtures, or like fixtures operating
at different temperatures, a 2 inch (51 mm)
partition kit is required. To join same temperature
merchandisers on different defrost cycles, a
plexiglass partition kit is required. Install 'J'
trim between cases.
a
ll joinTs musT be
-
air
TighT To prevenT
formaTion of ice
.
or condensaTion
P/N 0539221_T
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM
Use J-Bar to Align Cases for Joining
Remove Top Panel
Case End
Cap Bolt Hole
Locations
This bolt location
not present for
RFLTM
Advertisement
Table of Contents
