Installing End Assemblies - Hussmann INSIGHT REACH-IN Installation & Operation Manual

INSTALLING END ASSEMBLIES

The procedure for installing an end
assembly is similar to joining cases
together.
1. Remove the top and rear interior
panels from the left side of the case.
2. Apply gaskets as shown below.
Apply the wider Foam Tape Gasket (.906)
— 2 around the right end frame as shown
in the image below.
Next, apply Shoe Gasket — 4 to right
end first, then apply the narrower
Foam Tape Gasket — 3 around the
perimeter of the right end frame
outside of the donut gasket.
HUSSMANN CORPORATION • U.S. & CANADA 1-800-922-1919 • BRIDGETON, MO 63044-2483 • MEXICO 1-800-890-2900 • WWW.HUSSMANN.COM • PN 3181178_A
IRL / IRLN
1
/ / / / / / /
2
/ / / / / / / / / / / / / / / / / / / / / / / / / / / / /
3
Detail D
Right End
Install Donut Gasket
INSTALL DONUT GASKET
IN TO THE GROOVES
(seat into grooves)
Shoe
Gasket
1
2
/////////////////////////////
3
Overlap
Overlap Foam
Foam Gasket 3
Gasket As Shown
as Shown
Detail A
F
Right End Case-to-Case
R
Joint or End Panel Right End
Case-to-Case
O Joint or End Panel
RIGHT END
Apply Donut Gasket,
CASE-TO-CASE JOINT OR END PANEL
Foam Gaskets and
Apply Donut Gasket,
Gasket Pad to Right End APPLY DONUT GASKET, FOAM GASKETS
N
Foam Gaskets
AND GASKET PAD TO RIGHT END ONLY
Only
and Gasket Pad to
Right End Only
T
F
Right End
R
Apply Gasket Pad
O
N
T
Apply Gasket to Right End
1-11
Foam 1/2 inch x 1/4 inch
1
Foam 1/2 inch x 1/4 inch
/ / / / / / / /
Donut Gasket
2
Donut Gasket
Foam .906 inch x 1/2 inch x 200 inch
3
Foam .906 inch x 1/2 inch x 200 inch
/////////////////////////////
Butyl is NOT an acceptable
substitute for donut or
foam gasket.
Apply a bead of Silicone Sealant
APPLY A BEAD OF SILICONE ALONG
JOINING SURFACE AS SHOWN
along joining surface
Apply Shoe Gasket
3168104
GASKET-PATTERN SHOE STD RH IRI 2.0