Do Not Use; Cleaning Honeycomb Assemblies - Hussmann INSIGHT REACH-IN Installation & Operation Manual

DO NOT USE:

• Abrasive cleansers and scouring pads, as these will mar the finish.
• Coarse paper towels on coated glass.
• Ammonia-based cleaners on acrylic parts.
• Solvent, oil or acidic based cleaners on any interior surfaces.
DO:
• Remove the product and all loose debris to avoid clogging the
ANSI Z535.6-2011 (R2017)
waste outlet. Page 18
• Store product in a refrigerated area such as a freezer. Remove
only as much product as can be taken to the freezer in a timely Providing Information About Safety Messages in Collateral Materials and Product
manner.
• First turn off refrigeration, then disconnect electrical power.
• Thoroughly clean all surfaces with soap and hot water. Do not use
A1 Explanation of Signal Words and Symbols
steam or high water pressure hoses to wash the interior. These
Signal words and safety symbols that are used in a product's collateral materials or on the product may
will destroy the merchandisers' sealing causing leaks and poor
be defined in collateral materials if space is available.
performance.
A1.1 Safety Alert Symbol
• Remove screws and lift hinged fan plenum for cleaning. Be sure
The meaning of the safety alert symbol may be provided in collateral materials. The following artwork may
to reposition the fan plenum after cleaning merchandiser.
be used for this purpose.
• Take care to minimize direct contact between fan motors and
cleaning or rinse water.
• Rinse with hot water, but do not flood. Never introduce water
faster than the waste outlet can remove it.
• Allow merchandisers to dry before resuming operation.
• After cleaning is completed, turn on power and refrigerant to the
A1.2 Signal Words
merchandiser.
The meaning of the different signal words as defined by the ANSI Z535.6 and ANSI Z535.4 standards
may be explained in collateral materials. The following artwork may be used for this purpose.
• Verify that merchandiser is working properly.
» Product will be degraded and may spoil if
allowed to sit in a non-refrigerated area.
HUSSMANN CORPORATION • U.S. & CANADA 1-800-922-1919 • BRIDGETON, MO 63044-2483 • MEXICO 1-800-890-2900 • WWW.HUSSMANN.COM • PN 3181178_A
A1.3 Other Highlighting Conventions
Annex A
Safety Signs and Labels
(Informative)
This is the safety alert symbol. It is used to alert you
to potential physical injury hazards. Obey all safety
messages that follow this symbol to avoid possible
injury or death.
DANGER indicates a hazardous situation which, if not
avoided, will result in death or serious injury.
WARNING indicates a hazardous situation which, if not
avoided, could result in death or serious injury.
CAUTION indicates a hazardous situation which, if not
avoided, could result in minor or moderate injury.
NOTICE is used to address practices not related to
physical injury.
Safety instructions (or equivalent) signs indicate specific
safety-related instructions or procedures.
5-2

CLEANING HONEYCOMB ASSEMBLIES

Honeycombs should be cleaned every six months. Dirty honeycombs
will cause merchandisers to perform poorly. The honeycombs may
be cleaned with a vacuum cleaner. Soap and water may be used if all
water is removed from the honeycomb cells before reassembling. Be
careful not to damage the honeycombs.
1. Remove the sheet metal screws located in the top panels and
remove the top panels.
2. Lift the honeycomb assembly out.
3. Clean and dry the honeycomb.
4. After cleaning, reassemble in reverse order of removal.
Top Panel
Screws
Honeycomb
HONEYCOMB VIEW
Honeycomb
Honeycomb
Retainer
Side view of Case Canopy