Garmin G1000 Pilot's Manual page 82

FLIGHT INSTRUMENTS
- When navigating with an active departure procedure, the flight phase and CDI scale does not change
until the aircraft arrives at the last departure waypoint (if more than 30 nm from the departure airport) or
the leg after the last departure waypoint has been activated or a direct-to waypoint is activated.
• If after completing the departure procedure the nearest airport is more than 200 nm away from the aircraft
and the approach procedure has not yet commenced, the CDI is scaled for oceanic flight (2.0 nm).
• Within 31 nm of the destination airport (terminal area), the CDI scale gradually ramps down from 2.0 nm
to 1.0 nm over a distance of 1.0 nm; except under the following conditions:
- Upon reaching the first waypoint of an arrival route that is more than 31 nm from the destination airport,
the flight phase changes to terminal and the CDI scale begins to transition down from 2.0 nm to 1.0 nm
over a distance of 1.0 nm.
• During approach, the CDI scale ramps down even further (Figures 2-27 and 2-28). This transition normally
occurs within 2.0 nm of the final approach fix (FAF). The CDI switches to approach scaling automatically
once the approach procedure is activated or if Vectors-To-Final (VTF) are selected.
- If the active waypoint is the FAF, the ground track and the bearing to the FAF must be within 45° of the
final approach segment course.
- If the active waypoint is part of the missed approach procedure, the active leg and the preceding missed
approach legs must be aligned with the final approach segment course and the aircraft must not have
passed the turn initiation point.
CDI scale varies if VTF is activated
Figure 2-27 Typical LNAV and LNAV+V Approach Service Level
CDI Scaling
• When a missed approach is activated, the CDI scale changes to 0.3 nm.
• The system automatically switches back to terminal mode under the following conditions:
- The next leg in the missed approach procedure is not aligned with the final approach path
- The next leg in the missed approach procedure is not a CA, CD, CF, CI, CR, DF, FA, FC, FD, FM, IF, or TF
- After any leg in the missed approach procedure that is not a CA or FA
66
CDI scale is set to the smaller of 0.3 nm
or an angle set by the system
angle set
by system
2 nm
FAF
Garmin G1000 Pilot's Guide for the Diamond DA42NG
2 nm
CDI scale varies if VTF is activated
Figure 2-28 Typical LNAV/VNAV, LP, LP+V and LPV Approach
Service Level CDI Scaling
angle based
on database
information
FAF Landing
Threshold
190-00962-04 Rev. A