Garmin G1000 Pilot's Manual page 488

Integrated flight deck for diamond da42ng
Hide thumbs Also See for G1000:
Table of Contents

Advertisement

AUTOMATIC FLIGHT CONTROL SYSTEM
a
R
utomatic
eveRsion to
Several situations can occur while Vertical Path Tracking Mode is active which cause the flight director to
revert to Pitch Hold Mode:
• Vertical deviation exceeds 200 feet during an overspeed condition.
• Vertical deviation experiences a discontinuity that both exceeds 200 feet in magnitude and results in the
vertical deviation exceeding 200 feet in magnitude. Such discontinuities are usually caused by flight plan
changes that affect the vertical profile.
• Vertical deviation becomes invalid (the Vertical Deviation Indicator is removed from the PFD).
• A display enters Reversionary Mode (this does not apply to an active vertical direct-to).
Unless VNV is disabled, Vertical Path Tracking Mode and the appropriate altitude capture mode become
armed following the reversion to Pitch Hold Mode to allow for possible profile recapture.
n
-P
D
on
ath
escents
Pitch Hold, Vertical Speed, and Flight Level Change modes can also be used to fly non-path descents
while VNV flight control is selected. If the VS or FLC Key is pressed while Vertical Path Tracking Mode is
selected, Vertical Path Tracking Mode reverts to armed along with the appropriate altitude capture mode to
allow profile re-capture.
To prevent immediate profile re-capture, the following must be satisfied:
• At least 10 seconds have passed since the non-path transition was initiated
• Vertical deviation from the profile has exceeded 250 feet, but is now less than 200 feet
Pressing the VNV Key twice re-arms Vertical Path Tracking for immediate profile re-capture.
472
P
h
m
itch
olD
oDe
Figure 7-13 Flight Level Change VNV Non-Path Descent
Garmin G1000 Pilot's Guide for the Diamond DA42NG
190-00962-04 Rev. A

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents