Garmin G1000 Pilot's Manual page 81

When set to Auto (default), the GPS CDI scale automatically adjusts to the desired limits based upon the
current phase of flight (Figure 2-26, Table 2-1).
Departure
• Once a departure procedure is activated, the CDI is scaled for departure (0.3 nm).
• The system switches from departure to terminal CDI scaling (1.0 nm) under the following conditions:
- The next leg in the departure procedure is not aligned with the departure runway
- The next leg in the departure procedure is not a CA, CD, CF, CI, CR, DF, FA, FC, FD, FM, IF, or TF (see
Glossary for leg type definitions)
- After any leg in the departure procedure that is not a CA or FA
• At 30 nm from the departure airport, the enroute phase of flight is automatically entered and CDI scaling
changes to 2.0 nm over a distance of 1.0 nm, except under the following conditions:
190-00962-04 Rev. A
Figure 2-25 GPS CDI Settings
(AUX-System Setup Page)
Enroute
Terminal
(Oceanic if >200 nm
from nearest airport)
Figure 2-26 Automatic CDI Scaling
Garmin G1000 Pilot's Guide for the Diamond DA42NG
FLIGHT INSTRUMENTS
Refer to accompanying
approach CDI scaling figures
Terminal Approach
Missed
Approach
65