Installing The Power Interposer Board - Dell EMC NX430 System Owner's Manual

Figure 37. Removing and installing the power interposer board
1 standoffs (2)
3 power interposer board
5 28 pin cable to system board
7 8 pin cable to system board
Next steps
1 Install the power interposer board.
2 Follow the procedure listed in the After working inside your system section.

Installing the power interposer board

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in Before working inside your system section.
3 Keep the Phillips #2 screwdriver ready.
Steps
1 Align the power interposer board (PIB) with the standoffs on the chassis.
2 Install the two screws that secure the PIB to the chassis.
3 Connect the power distribution cables to the system board and fan cable connector to PIB.
90 Installing and removing system components
2 10 pin cable to hard drive backplane
4 screw (2)
6 4 pin cable to system board