Installing The Internal Perc Card - Dell EMC NX430 System Owner's Manual

Figure 24. Removing and installing the internal PERC card
1 screw (2)
3 PERC card
5 PERC card LED cable
7 LED cable connector on the system board
Next steps
1 Install the internal PERC card.
2 Install the expansion card riser.
3 Follow the procedure listed in the After working inside your system section.

Installing the internal PERC card

Prerequisites
1 Follow the safety guidelines listed in Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 Remove the expansion card riser.
4 Keep the Phillips #2 screwdriver ready.
Steps
1 Connect the PERC LED cable to the LED cable connector on the PERC card.
2 Insert the PERC card in the PERC card slot.
3 Press and slide the tab on the PERC card lock to disengage it from the slot on the chassis.
4 Turn the internal PERC card lock to engage it with the PERC card.
5 Install the first screw to secure the PERC card lock to the PERC card.
6 Install the second screw to secure the PERC card to the chassis.
NOTE: Use the two screws supplied with the system to secure the PERC card to the PERC card lock and the chassis
7 Connect the PERC LED cable to the LED cable connector on the system board.
Next steps
1 Install the expansion card riser.
2 Follow the procedure listed in the After working inside your system section.
2 PERC card lock
4 LED cable connector on the PERC card
6 PERC card connector
Installing and removing system components 73