Installing The Power Interposer Board - Dell XC430 Owner's Manual

Figure 30. Removing and installing the power interposer board
1. standoffs (2)
3. fan cable connector
5. power supply cables to the system board
(3)

Installing the power interposer board

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
Steps
1. Align the power interposer board (PIB) with the standoffs on the chassis.
2. Install the two screws that secure the PIB to the chassis.
3. Connect the power distribution cables to the system board and fan cable connector to PIB.
Next steps
1. Follow the procedure listed in After working inside your system section.
2. power interposer board
4. screw (2)
87