Installing A 2.5-Inch Hot Swappable Hard Drive Into A 3.5-Inch Hard Drive Adapter - Dell EMC NX430 System Owner's Manual

NOTE: Hot swappable hard drives are supplied in hot swappable hard drive carriers that fit in the hard drive slots.
1 If installed, remove the hard drive carrier blank.
2 Install a hot swappable hard drive into the hot swappable hard drive carrier.
Steps
1 Press the release button on the front of the hot swappable hard drive carrier and open the hot swappable hard drive carrier handle.
2 Insert the hot swappable hard drive carrier into the hard drive slot, and push the hot swappable hard drive carrier until it comes in
contact with the backplane.
3 Close the hot swappable hard drive carrier handle to lock the hot swappable hard drive carrier in place.
Next step
If removed, install the front bezel.
Installing a 2.5-inch hot swappable hard drive into a 3.5-inch
hard drive adapter
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Follow the safety guidelines listed in Safety instructions section.
2 Keep the Phillips #2 screwdriver ready.
Steps
1 Align the screw holes on the 2.5-inch hot swappable hard drive with the screw holes on the 3.5-inch hard drive adapter.
2 Install the screws to secure the 2.5-inch hot swappable hard drive to the 3.5-inch hard drive adapter.
Figure 17. Installing a 2.5-inch hot swappable hard drive into a 3.5-inch hard drive adapter
1 3.5-inch hot swappable hard drive carrier
3 3.5-inch hard drive adapter
Next step
Install the 3.5-inch adapter into the 3.5-inch hot swappable hard drive carrier.
60 Installing and removing system components
2 screw (5)
4 2.5-inch hot swappable hard drive