Installing A Cooling Fan; Expansion Cards And Expansion Card Riser; Expansion Card Installation Guidelines - Dell EMC NX430 System Owner's Manual

Installing a cooling fan

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
NOTE: The procedure for installing each fan is identical.
1 Follow the safety guidelines listed in safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 If installed, remove the cooling fan blank.
4 If required, remove the cooling shroud.
Steps
1 Lower the fan into the cooling fan bracket.
2 Connect the power cable to the power cable connector on the system board.
Next steps
1 Install the cooling shroud.
2 Follow the procedure listed in the After working inside your system section.

Expansion cards and expansion card riser

An expansion card in the computer is a add-on card that can be inserted into an expansion slot on the computer system board or riser card
to add enhanced functionality to the system through the expansion bus.
NOTE: A System Event Log (SEL) event is logged if an expansion card riser is unsupported or missing. It does not prevent your
system from turning on and no BIOS POST message or F1/F2 pause is displayed.
NOTE: The expansion card riser is optional for systems with four hard drives.

Expansion card installation guidelines

Your system supports PCIe Express Generation 3 cards. The following table provides riser configurations for NX430 systems:
Table 14. Expansion card slots available on the expansion card riser
PCIe slot on the expansion card
riser
LP SLOT 1
FH SLOT 2
Table 15. Expansion card slots available on the system board
PCIe slot on the system board
PCIE_G3_X4
NOTE: The expansion cards are not hot-swappable.
Height
Half Height
Full Height
Height
Half Height
Length Link width
Half Length x4
Half Length x8
Length Link width
Half Length x4
Installing and removing system components
Slot width
x8
x16
Slot width
x8
67