Installing The Optional Idrac Port Card - Dell EMC NX430 System Owner's Manual

Steps
1 Loosen the screw securing the iDRAC port card holder to the system board.
2 Pull the iDRAC port card to disengage it from the iDRAC port card connector on the system board, and remove the card from the
chassis.
Figure 26. Removing and installing the iDRAC port card
1 screw
3 iDRAC port card board
5 tabs on the iDRAC port
7 iDRAC port card connector
Next steps
1 Install the iDRAC port card.
2 Install the cooling shroud.
3 If disconnected, reconnect the network cable.
4 Follow the procedure listed in the After working inside your system section.

Installing the optional iDRAC port card

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
2 iDRAC port
4 SD vFlash media card slot
6 slots on the chassis
8 iDRAC port card holder
Installing and removing system components 75